1 Vertical storage, cartons can be added at any time without stopping the machine; Case Unpacker,Case Erector Machine,Automatic Unpacking Machine,Case Unpacking Machine Shandong Sinolion Machinery Corp. Ltd , https://www.packingline.nl
The planer is an automatic feeding and high-efficiency woodworking machine. It is mainly used for plates or squares that have been cut through two reference planes, and then processed to the opposite side to make it a net of certain thickness and width. To ensure safety, the following points should be noted during operation:
1) Before operation, carefully check whether the mechanical parts and safety protection devices are good, and then carefully adjust the machine according to the size required by the wood and the scale of the machine tool. After the adjustment is appropriate, test run for 1 to 3 minutes. After the rotation speed is normal, the feed can be fed, and the depth of each knife should not exceed 2 mm.
2) When operating, the two should cooperate well, one person feeds and one person picks up the materials. Stand on the left and right side of the planer or later to prevent the workpiece from flying out and hurting people. Do not place the fingers under the workpiece when feeding. The receiving workers should wait for the workpiece to leave the discharge roller and pick up the material. Do not pull it hard. When feeding the hand, keep the hand away from the roller.
3) During the planing, if the wood does not move, it can be propelled by the safety rod; if it is invalid, the feed roller should be stopped first, then the cutter shaft should be stopped, and the table should be lowered after the stop, and the workpiece should be taken out to eliminate the fault.
4) Several workpieces with a thickness difference greater than 2mm are not allowed to be shaved at the same time, in case the thin workpiece is bounced back due to the pressure.
5) During the operation, the wood residue, wood chips and resin stuck on the table top and the drum should be removed frequently in the gap between the lower drum and the table. When clearing, stop or land on the countertop and use a wooden stick to pull it out.
6) When replacing the planer, it should be done after the machine is turned off and wait for the tool shaft to naturally stop. It is not allowed to force the cutter shaft to stop rotating.
2 Suitable for forming and sealing cartons of the same size.
3 Manually adjust to change the carton sizes(finishing in 2-3minutes);
4 Case Erector adopt Advanced photo electric induction control system
5 Rationally designed, the forming, folding and sealing process are accomplished simultaneously;
6 Cutter Safety system to prevent hands form stabbed by the cutter
1 Vertical storage, cartons can be added at any time without stopping the machine;
Case Unpacker,Case Erector Machine,Automatic Unpacking Machine,Case Unpacking Machine
Shandong Sinolion Machinery Corp. Ltd , https://www.packingline.nl